Step 3: Start Configuration

To configure the device(s), follow these steps:

  1. To program with a MasterBlaster download cable, attach the MasterBlaster cable to an RS-232 cable connected to a serial RS-232 port on the PC or UNIX workstation.

  2. Connect the 16-pin female header end of the cable to the 16-pin male MasterBlaster port, and the 10-pin female end of the cable to the 10-pin male header on the target printed circuit board.

  3. Click Start in the Programmer window. When you receive a message indicating that the configuration is complete, click OK.

Go to: Refer to the Quartus II Installation & Licensing for PCs manual or the Quartus II Installation & Licensing for UNIX and Linux Workstations manual for more information about setting up programming hardware.

Decision Point Icon spacer
If you want to continue to the next tutorial module, proceed to the LogicLock module.

If you want to start another tutorial module, return to Start the Tutorial.